10060 Hardware HARDWARE: External Debris Blower Filters Not Present All The debris cabinet is reporting that the filters are not present. Check the filter itself, the sensor inside the cabinet, and the cable running to the device. If everything looks fine, the error can be masked off temporarily in later versions of firmware. Check the mask table for "DBlower Filter Fault". The device cannot detect the debris filter inside the debris cabinet. Open the cover of the cabinet and check to make sure the filter is sitting solidly inside the cabinet. Check the cable running from the debris cabinet to the device. If it is loose, plug it in securely and try again. If everything looks fine and the error comes up again, contact the CreoScitex Response Centre. Filter has been removed from debris cabinet. Faulty cable from debris cabinet to device. Faulty sensor inside debris cabinet. ../commands/dr.xmlCommand: dr ../commands/mask.xmlCommand: mask ..\..\ShowAllErrors.htmFirmware 0 Error Index ..\..\ShowAllCommands.htmFirmware 0 Command Index ..\..\ShowAllNVS.htmFirmware 0 NVS Index Updated: Wed Jul 16 19:32:30 2008 PST